Powered by the Sun

This range of series regulators is designed for alternative energy charging systems ranging in size from 0.1A to 100A. They are ideal regulators for charging inputs from PV, Permanent Magnet Wind and Water Generators. They also include the Charge Divert feature. Charge Divert allows you to use the excess charging source energy for other tasks, or for placing a load on permanent magnet charging sources such as wind generators to prevent over speed conditions. The Divert connection is only activated after the charging source is making energy and the batteries are not using the energy (i.e. A wind generator will not be starting into the divert load). Multiple battery banks can be charged with the use of a standard battery charging isolators.

• 5 year warranty.
• Completely sealed electronics for marine or outdoor mounting.
• Low battery voltage indicator. (flashing red light).
• Arc reduction circuitry to eliminate or reduce relay contact wear.
• Charging efficiency better than 99.50% from 0.5a to 30a of charging current.
• Operates efficiently (98%) with as little as 0.1a of solar panel charging current.
• Efficiently charges batteries from 0 volts with full power.
• Ddiverts only when voltage and current are at usable levels. perfect for motor type divert loads (fans, pumps, etc...)
• Charges with the same high accuracy through battery isolators.
• Charges batteries at full power, below the plate saturation point, this charges batteries faster, and reduces electrolyte depletion by up to 90% over conventional constant voltage, pwm, & high frequency charge regulators.
• Reverse polarity and transient voltage protection on the battery sense wires.
• No power wasting sample periods.
• Remote battery voltage sensing so the controller can be mounted anywhere between the charging source and the batteries.
• Easy to install using the labeled corrosion resistant nickel / brass / stainless steel connector.
• Up to 200 amp charge divert, optional.
• Stable divert circuitry prevents dropouts if charge source voltage falls too low.
• Diverts only when voltage and current are at usable levels. perfect for motor type loads (fans, pumps, etc...)
• Peak charge voltage adjustment